Marzhauser Sensotech SensorReady 3D Betriebsanleitung Seite 79

SensorReady 3D
X
1 Start GetPos by double-clicking on the file GetPos.exe
When GetPos is started for the first time, the dialogue window
GetPos Setup appears. Here, you can make all the settings
required to establish the connection between SensorReady 3D
and GetPos.
Once the settings have been made, the dialogue window Get-
Pos Setup no longer appears when GetPos is started. You can,
however, adjust all the settings at any time using the Settings
menu in the menu bar.
»
NOTICE
Incorrect data transmission and measurement caused by
incorrect configuration.
During configuration of GetPos, always enter the correct inter-
face and the correct number of measuring systems (axes).
2 Select the virtual Port via which the SensorReady 3D is con-
Configuring GetPos
Chapter 6.1.3 Menu Functions, page 82
nected to your PC.
Operation
79