Marzhauser Sensotech SensorReady 3D Betriebsanleitung Seite 74

Putting into Service
NOTICE
Equipment damage possible from by connecting inappro-
priate measuring systems.
Only connect incremental measuring systems of type MR/ana-
log 5Vss, 1Vss or TTL (RS-422) without external power supply
to port Encoder 3.
Incorrect data transmission through unshielded cables
possible.
Only use shielded cables for connecting measuring systems, PCs
and other peripherals.
3 Connect your 3rd measuring system to port Encoder 3 on the
4 If you are using a reference switch in connection with your
5 Connect the power supply of the SensorReady 3D to the mains.
The status LED lights up. The SensorReady 3D is ready for ope-
ration.
6 If you are using a measuring system of type MR/analog 5Vss,
Your 3rd measuring system can now be evaluated by the
SensorReady 3D.
74
SensorReady 3D. Use an appropriate encoder cable for this.
3rd measuring system, connect the reference switch to the
port Feature Connector. Use an appropriate cable for this.
»
Chapter 2.1 Optional Accessories, page 63
Note: If your 3rd measuring system has reference marks,
the reference signal is transmitted via port Encoder 3 to the
SensorReady 3D.
you must calibrate your 3rd measuring system. For this pur-
pose, move your third axis at least 1 cm in both directions.
Note: The calibration is kept after switching off the
SensorReady 3D and is continually updated during opera-
tion. Measuring systems of type 1Vss and TTL (RS-422) do
not need to be calibrated.
Operating Manual