General; Batteries; Replacing The Batteries Of The Remote; Replacing The Batteries Of The Receiver - WANDERS Cocos Bedienungsanleitung Und Installationsvorschriften

General

It is common practice for the dealer where you purchased your gas fireplace to take also care of installing
it and connecting it to the gas mains. If this is not the case, please ensure that the installation is done by a
certified installer. Connecting gas devices by unqualified persons is prohibited, in which case we cannot give
any guarantee that your gas hearth is functioning properly.

Batteries

The batteries of the remote handset and the receiver will last for about one year. We recommend that you use
alkaline batteries.
You need to replace them when the LED of the remote set becomes dimmer and the word "BATT" appears in
the display. The receiver will warn you if it's batteries need to be exchanged. You'll hear, during ignition, a beep
for 0.8 seconds followed by 0,2 seconds silence.

Replacing the batteries of the remote

Open the lid in the backside cover. Gently remove the 9V block battery and disconnect
it from the contact holder. Avoid pulling the cable. Connect the new battery, replace
the set, and close the lid.

Replacing the batteries of the receiver

Gently pull the whole receiver from the holder behind the cover frame. Slide the
lid open and place 4 new 1.5V batteries (type LR6 of AA). Ensure that you place the
batteries into the receiver correctly. Then place the receiver again in the fireplace.

Setting the remote control handset

Once the batteries are placed, you need to set the electronic code (only when using it for the first time). Press
the reset button on the receiver until you hear 2 acoustic signs, and then release the reset button. Then press
the small flame button
been set.

Setting the time

Press the big-flame button
ously, and the display will show short flashes to indicate that you are in
the set mode.
When in the set mode, press the big-flame button
and press the small-flame button
Wait or press the OFF button
18
Downloaded from www.Manualslib.com
within 20 seconds until you hear a long acoustic signal to confirm that the code has
and the small-flame button
to set the minutes.
to return to manual control.
manuals search engine
simultane-
to set the hours,