Changing The Rinse Aid Dose - hanseatic HGTI6082C13K7709DS Gebrauchsanleitung

Dishwasher detergents, rinse aids and dishwasher salts
1. Open the cover to the rinse aid
compartment (21).
2. Fill the water tank to the "max" mark in
the opening.
3. Wipe away any rinse aid which has spilt
immediately so that you don't compro-
mise the rinsing results and to avoid in-
creased foaming.
4. Close the cover to the rinse aid compart-
ment again.

Changing the rinse aid dose

We would recommend that you do not change
the dose that was set by the factory initially.
If the dishes are
– matt and stained after cleaning, increase
the dose.
– sticky and streaky, you should decrease
the dose.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button.
(1) (2)
(8)
2. Press the P button (4) for 5 seconds with-
in 60 seconds of switching on.
3. Push the button (2) to switch to setting
mode.
The signal will flash. The current value
( to ) will illuminate on the display (8).
d1 d5
4. Press the P button (4) repeatedly until the
desired dose is displayed (
= high).
d5
5. Around 5 seconds after you push it for the
last time, the dishwasher will automatically
revert to the normal display.
The selected dose setting is saved.
Page EN-15
(1)
(4)
= low,
d1