Basic Diagnostics; Module Not Heating; Note On Safety Reset Switches; Tap Not Dispensing - modbar POUR OVER SYSTEM Betriebsanleitung

O M P O S
PERATING ANUAL OUR VER YSTEM

Basic diagnostics

Module not heating

Verify that the power switch is turned clockwise to the operating mode position and not counter
clockwise to the standby mode position.

Note on safety reset switches:

The pour over module features two safety reset thermostat controlled switches, one on each boiler. If a
boiler does not heat it may be due to the activation of one of these switches, which is triggered by
excess temperature and signifies abnormal operation and possibly failed components. The safety
switches mentioned are all internal to the pour over module and are not user re settable. If you believe
a safety switch has been activated, the module or tap may require service by an authorized
technician. Please contact Modbar for additional support and information.

Tap not dispensing

Verify that the water supply to the module is turned on. If you are still having trouble dispensing, verify
that the flow control valve on the tap connection is not all of the way closed.

Button only dispenses in manual.

Verify that you have a program assigned to the button in question. Check this in the profile screen, and
verify that the profile is assigned left or right.

Module not dispensing water

Verify that water is turned on to the module.
Verify that water pressure is adequate. The operable pressure range for Modbar equipment is 0.25
0.50MPa. If water pressure is too low, the module will not dispensing water.
34