Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
O
M
PERATING
ANUAL
13. Touch Save & Exit to store your settings and return to the previous screen.
14. To assign your profile to one of the buttons above the counter, touch the name of the profile so
that it is highlighted, then touch Assign Left or Assign Right to assign it to the button.
15. Your profile is now ready to be used.
16. For Manual Programming you must first assign your profile to one of the buttons above the
counter, touch the name of the profile so that it is highlighted, then touch Assign Left or Assign
Right to assign it to the button.
17. Prepare the coffee and device you wish to use for this profile.
18. Rinse the paper and/or filter basket to warm the pour‐over device and the pour‐over tap
plumbing.
19. Press and hold the dispensing switch to which you previously assigned the profile (left or right)
for approximately 3 seconds until the button begins to flash. (flashing indicates that you are in
"recording" mode). Water will begin to flow.
20. Momentarily pressing the dispense switch will pause the flow of water, pressing again will
resume the flow, all the while volumetric and time based data are being stored in the profile
memory. Also note that the total volume of water dispensed is displayed on the module display
in real time. This value may be used to assist in performing your brew cycle.
21. When you are finished with the brewing cycle, momentarily press the dispensing switch to stop
the water flow (the switch will still flash). Hold the dispensing switch down until both left and
right dispense switches flash. This indicates that the program has been stored to the selected
profile.
P
O
S
OUR
VER
YSTEM
18
Werbung
Kapitel
Inhaltsverzeichnis
