modbar POUR OVER SYSTEM Betriebsanleitung Seite 16

O M
PERATING ANUAL
8. It is possible to set a pre‐wet volume. This is expressed as a percentage of the total volume.
Touch the number next to Prewet Percent. Rotate the encoder to increase or decrease in 1%
increments, push the joystick up or down to change in 0.1% increments and left or right to
change in 10% increments. Press the centre of the joystick to set. The calculated volume of the
pre‐wet will be displayed.
9. To set the delay time between the pre‐wet and the rest of the water dispense, touch the
numbers next to Prewet delay. Rotate the encoder to increase or decrease in 1 second
increments, push the joystick up or down to change in 0.1 second increments and left or right to
change in 10 second increments. Press the centre of the joystick to set.
10. The water can be dispensed in a series of pulses. The number of pulses can be set by touching
the number next to Pulse Count. Rotate the encoder to increase or decrease in 1 pulse
increments, push the joystick up or down to change in 1 pulse increments and left or right to
change in 10 pulse increments. Press the centre of the joystick to set. (minimum 1, maximum 12
pulses).
P
OUR
O S
VER YSTEM
15