Steps To Creating A New Pour Over Profile - modbar POUR OVER SYSTEM Betriebsanleitung

O M
PERATING ANUAL
Steps to creating a new pour-over profile:
1. Select an empty profile (indicated by a non‐filled circle) and choose edit.
2. Touch next to the Profile Name field and enter a name for the profile. Use the joystick and
encoder wheel to navigate the alpha‐numeric character set.
3. Set the heat zone temperatures if desired. To change the set temperature, simply touch the
temperature value on the screen and the value will be highlighted. Rotate the encoder left or
right to change the value in 1‐degree increments. Press the joystick up or down to change the
temperature in 1/10 degree increments. Press the center button on the joystick to save the
change.
● In manual temperature mode, both boiler heat zones will be displayed. Set the Inlet
Boiler Temperature (Inlet‐T) and Outlet Boiler Temperatures (Outlet‐T) if so desired.
● In automatic temperature mode, only one temperature will be displayed. Set the brew
temperature (Temp) if so desired.
(Refer to "Advanced preferences screen page 2" for temperature mode information)
4. If you want to program the profile parameters manually, touch the Manual Programming box. It
will turn red and the Brew Settings option will disappear.
Touch Save & Exit and then Go to step 16.
P
OUR
O S
VER YSTEM
13