Mounting Of Protector - Makita EM4351UH Originalbetriebsanleitung

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/protector
combinations as indicated in the table must be used.
Be sure to use genuine MAKITA metal blades (including
saw blade and cutter blade) or nylon cutting head.
– The metal blade must be well polished, free of cracks or
breakage. If the metal blade hits against a stone during
operation, stop the engine and check the blade immediately.
– Polish or replace the metal blade every three hours of
operation.
– If the nylon cutting head hits against a stone during
operation, stop the engine and check the nylon cutting head
immediately.
CAUTION: The appropriate protector must always be installed,
for your own safety and in order to comply with
accident prevention regulations.
Operation of the equipment without the guard being
in place is not permitted.
The outside diameter of the cutter blade must be
300 mm (12") or smaller. Never use any blades
exceeding 300 mm (12") in outside diameter.
Use 200 mm saw-blade protector only when using
200 mm saw-blade.
Use 225 mm saw-blade protector only when using
225 mm saw-blade.
Do not apply other combination when using saw-
blade.
NOTE: The standard combination of cutting tool differs from
county to country.
Downloaded from www.Manualslib.com manuals search engine
Cutter blade
200 mm saw blade
225 mm saw blade
Nylon cutting head
10
Protector for metal blades
Protector for
200 mm saw blade
Protector for 225 mm
saw blade
Protector for
nylon cutting head