Mounting Of Protector - Makita RBC421L Original Bedienungsanleitung

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/protector combinations
as indicated in the table must be used.
Be sure to use genuine MAKITA cutter blades or nylon cutting
head.
– The cutter blade must be well polished, free of cracks or breakage. If the cutter blade hits against a stone during operation, stop the engine
and check the blade immediately.
– Polish or replace the cutter blade every three hours of operation.
– The outside diameter of the cutter blade must be 255mm (10-1/32"). Never use any blades surpassing 255mm (10-1/32") in outside
diameter.
– If the nylon cutting head hits against a stone during operation, stop the engine and check the nylon cutting head immediately.
– The mounting hole for the cutter blade is 25.4mm (1").
Star Blade
CAUTION: The appropriate protector must always be installed, for your own
safety and in order to comply with accident-prevention regulations.
Operation of the equipment without the guard being in place is not
permitted.
– Fix the protector (1) to the clamp (3) with two bolts M6 x 30 (2).
NOTE: Tighten the right and left bolts evenly so that the gap between the
clamp (3) and the protector (1) will be constant.
Otherwise, the protector sometimes may not function as specified.
– In use of the nylon cutting head insert the protector (6) into the protector (1),
and fasten them with two screw (4) and two nuts (5).
Eddy Blade Brush Blade Protector for metal blades
Nylon cutting head
(4)
(6)
11
Protector for cord cutter
(1)
(5)