Mounting Of Protector - Makita EM3400U Originalbetriebsanleitung

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/protector combinations as indicated in the table must be used.
CAUTION: The appropriate protector must always be installed,
for your own safety and in order to comply with
accident prevention regulations.
Operation of the equipment without the guard being
in place is not permitted.
NOTE: The standard combination of cutting tool differs from
county to country.
–
(1).
NOTE: Tighten the right and left bolts evenly so that the gap between the clamp
(2) and the protector (3) will be constant.
– In cases where the nylon cord cutter is to be used, be sure to mount the
nylon cord cutter protector (4) onto the metal blade protector (3).
CAUTION: Take care not to injure yourself on the cutter for cutting the nylon
cord.
(For model EM3400U only)
Attaching the fastener
Fix the control cable and shaft by the fastener (1) in the area shown in the
Metal blade
Nylon cutting head
(1)
(3)
10
Protector for metal blades
Protector for
nylon cutting head
(2)
(3)
(4)
(1)