Makita EM4351UH Originalbetriebsanleitung Seite 23

5) Set the engine level, and gradually fill up to upper limit mark with new oil.
6) After filling, tightly secure oil cap, so that it will not loosen and cause leaks.
If oil cap is not tightly secured, it may leak.
POINTS ON OIL
– Never discard replaced engine oil in garbage, earth or sewage ditch.
Disposal of oil is regulated by law. In disposal, always follow the relevant
laws and regulations. For any points remaining unknown, contact
Authorized Service Agent.
– Oil will deteriorate even when it is kept unused. Perform inspection and
replacement at regular intervals (replace with new oil every 6 months).
CLEANING OF AIR CLEANER
WARNING: Shut off the engine, keep away from open flames
Interval of Cleaning and Inspection: Daily (every 10 operating hours)
– Turn the choke lever to the full close side, and keep the carburetor off from
dust or dirt.
Removing air cleaner cover
– Release the hook on the air cleaner cover by pressing down the loop on the
plate.
– Loosen fixing bolt.
– Pull and remove the air cleaner cover.
Cleaning element
– Remove the elements and tap them to remove dirt.
– For heavy contamination:
1) Remove the element (sponge), immerse it in warm water or in water-
diluted neutral detergent, and dry it completely. Do not squeeze or rub it
when washing.
2) Clean the element (paper) by tapping it gently. If you can use an air blow
gun, blow the compressed air onto the inside of the element (paper). Do
not wash the element (paper).
– Before attaching the element (sponge), be sure to dry it completely.
Insufficient drying of the element (sponge) may lead to difficult start-up.
– Wipe out oil adhering around the air cleaner cover and separator plate with
waste cloth.
Attaching air cleaner cover
– Fit the element (sponge) and element (paper). Insert the element (sponge) all
the way into the air cleaner cover.
– Insert the side hook onto the air cleaner cover as illustrated, and push the
lower part of the air cleaner cover until it clicks so that the hook sits into the
loop properly. And then tighten the air cleaner cover with fixing bolt.
NOTICE:
– Clean the elements several times a day, if excessive dust adheres to it.
Dirty elements reduce engine power and make starting engine difficult.
– Remove oil on the elements. If operation continues with the elements
remaining not cleared of oil, oil in the air cleaner may fall outside, resulting
in contamination of the environment.
– Do not put the elements on the ground or dirty place. Otherwise they pick
up dirt or debris and it may damage the engine.
– Never use fuel for cleaning the elements. Fuel may damage them.
Downloaded from www.Manualslib.com
and do not smoke.
manuals search engine
Element (paper)
Fixing bolt
Air cleaner cover
Element (sponge)
23
Plate
Loop
Separator plate
Element (sponge)
Air cleaner cover
Hook
Side hook