Cleaning And Care; Shaver; Shaving Attachment / Blade Unit - Silvercrest SRR 3.7 C4 Bedienungsanleitung

• Figure H: when trimming your beard,
hold the device so that the front part of
comb attachment 1 slides over the skin.
• Use the device only with the beard trim-
mer attachment 3 and without comb at-
tachment 1, to cut beard and hairline.
In this way you can cut hair lengths of
1-2 mm evenly.

7. Cleaning and care

DANGER! Risk of electric
shock!
The hand-held part must be disconnect-
ed from the cable of the power unit be-
fore it is cleaned with water.
WARNING! Risk of injury!
Always switch off the device before
cleaning it.
WARNING! Risk of material damage!
The blade unit 4 of the shaving attach-
ment 5 can be cleaned using water. Do
not use any other liquids.
Do not use any astringent or abrasive
cleaning agents.
NOTE: clean the device after every use.

7.1 Shaver

• Wipe down the housing of the shaver 8
with a damp cloth.
7.2 Shaving attachment /
blade unit
Dry cleaning of the shaving
attachment
1. Clean the 3 shaving heads 4 after each
shave using the cleaning brush 20.
2. Press the release button 6 on the shav-
ing attachment 5, so that the blade
unit 4 opens.
3. Carefully tap the blade unit 4 to empty it.
26 GB
4. Remove the hair remnants by using the
cleaning brush 20.
Wet cleaning of the blade unit
The shaving heads 4 of the shaving attach-
ment 5 can be cleaned with water.
1. Press the release button 6 on the shav-
ing attachment 5, so that the blade
unit 4 opens.
2. Clean the blade unit 4 under running
water. Allow the water to flow through
the shaving heads 4 from the inside to
the outside.
3. Allow the parts to dry completely.
4. Close the blade unit 4, so that it clicks
into place.
Thorough cleaning of the blade
unit
An integrated timer in the device adds up
shaving times. After a shaving period of
30 minutes, the cleaning symbol 13 starts
flashing. It reminds you of the thorough
cleaning that you should regularly perform.
If you switch off the device while the clean-
ing symbol is flashing, the timer will start
counting shaving times again from the be-
ginning.
1. Press the release button 6 on the shav-
ing attachment 5, so that the blade
unit 4 opens.
2. Figure D: pull the blade unit 4 off the
shaving attachment 5 by overextending
it.
3. Figure E: carefully turn the locking
wheel 17 marked with arrows against
the direction of the arrows, until the
holder of the shaving heads 18 can be
lifted off.
4. Clean all parts under running water,
and then allow them to dry completely.
5. Reassemble the blade unit 4.
6. Figure F: carefully turn the locking
wheel 17 in the direction of the arrows,
until the holder of the shaving
heads 18 can no longer be lifted off.