Long-Hair Trimmer Attachment; Cleaning, Care And Maintenance - Silvercrest SLS 3 A1 Bedienungsanleitung

Long-hair trimmer attachment

If you do not want to completely shave off the hair or
merely want to trim your bikini line, use the long-hair
trimmer attachment w .
1) Push the long-hair trimmer attachment w onto the
shaver unit 2 and press it down so that the long-hair
trimmer attachment w clicks into place . Ensure that the
open grooves lie over the trimmer 1 .
2) Press the travel lock and push the on/off switch 5
in the direction of the shaver unit 2 . The appliance
starts .
3) Move the appliance with straight motions over the
skin . Apply repeatedly and guide the shaver against
the direction of hair growth .
4) After you have covered all the areas you want to
shave, push the on/off switch 5 back into its initial
position . The appliance stops .
5) Clean the long-hair trimmer attachment w with the
supplied cleaning brush 9 . For a more thorough
cleaning, read the section "Cleaning, care and
maintenance" .

Cleaning, care and maintenance

CAUTION! MATERIAL DAMAGE!
► Do not use abrasive, chemical or caustic cleaning
agents to clean this appliance . This will irreparably
damage the appliance .
NOTE
► As soon as the shave becomes noticeably worse, we
recommend replacing the shaver unit 2 .
To order a new shaver unit 2, please contact the
service department (see section "Ordering replace-
ment parts") . Have the IAN number of the item to
hand . You will find this on the front page of these
operating instructions or in the section "Service" .
SLS 3 A1
GB │ IE │ NI │ 9 ■