Danger From Batteries - Silvercrest SRR 3.7 C4 Bedienungsanleitung

Should liquid enter the device, have it
checked before starting the device up
again.
If the device is used in a bathroom, the
power unit must be pulled out after use,
as the proximity of water represents a
hazard, even when the device is
switched off.
Installation of a residual current device
(FI/RCD) with a rated residual operat-
ing current of no more than 30 mA is
recommended to provide additional
protection. Ask your electrician for ad-
vice. The installation should only be car-
ried out by a qualified electrician.
DANGER! Risk of electric
shock
Never put the device into operation if
there are visible damages to the device,
the power unit or the cable or if the de-
vice has been dropped before.
Connect the cable to the device before
plugging the power unit into a wall
socket.
Only connect the power unit to a proper-
ly installed, easily accessible wall socket,
the voltage of which corresponds to the
specifications on the rating plate. The
wall socket must continue to be easily ac-
cessible after the device is plugged in.
Ensure that the cable cannot be dam-
aged by sharp edges or hot surfaces.
Ensure that the cable is not trapped or
crushed.
When removing the power unit from the
wall socket, always pull the power unit
and never the cable.
Pull the power unit out of the wall
socket, ...
... after every use,
... after each charging process,
... if there is a fault,
... before connecting the device to the
cable,
... before you clean the device and
... during thunderstorms.
22 GB
To avoid any risk, do not make modifi-
cations to the device. Repairs must be
carried out by a specialist workshop or
the Service Centre.

DANGER from batteries

This device contains a battery that can-
not be removed. The battery may only
be removed or replaced by the manu-
facturer, the manufacturer's customer
service department or a similarly quali-
fied specialist, in order to avoid any
hazards.
Protect the battery against mechanical
damages. Fire hazard!
Do not expose the device to direct sun-
shine or heat. The ambient temperature
should not be lower than -10 °C and
higher than +40 °C.
The charge contacts on the device must
not be connected by metallic objects.
The battery may only be charged with
the original accessory (power unit).
Should the electrolyte solution leak out
of the battery, avoid contact with eyes,
mucous membranes and skin. Rinse im-
mediately with plenty of clean water
and consult a doctor. The electrolyte
solution can cause irritation.
The device is provided with a lithium-
ion battery.
- The battery cannot be removed!
- This device must not be opened!
- The device with the installed battery
must be disposed of properly.
WARNING! Risk of injury from
cutting
The points of the beard trimmer attach-
ment are sharp. Handle with care.
Do not use the device if the attachment
shows damages.
Switch off the device before pinning up
or changing the attachments and each
time before cleaning.