Cleaning And Maintenance; Cleaning Agents - CONSTRUCTA CD688860 Gebrauchs- Und Montageanleitung

Cleaning and maintenance

:
Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Risk of electric shock!
Penetrating moisture may result in an electric shock. Clean the
appliance using a damp cloth only. Before cleaning, pull out the
mains plug or switch off the circuit breaker in the fuse box.
:
Risk of electric shock!
Do not use any high-pressure cleaners or steam cleaners,
which can result in an electric shock.
:
Risk of injury!
Components inside the appliance may have sharp edges. Wear
protective gloves.
:
Risk of injury!
Risk of trapping body parts when opening and closing the
glass front. Do not reach into the area behind the glass panel,
and keep your fingers away from the hinges.

Cleaning agents

To ensure that the different surfaces are not damaged by using
the wrong cleaning product, follow the instructions in the table.
Do not use any of the following:
Harsh or abrasive cleaning agents, e.g. scouring powder or
■
liquid scouring cleaner,
Cleaning products with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
Pressure washers or steam cleaners,
■
Cleaning products that dissolve limescale,
■
Aggressive all-purpose cleaning products,
■
Oven spray.
■
Note: Wash new sponge cloths thoroughly before use.
Note: Follow all instructions and warnings included with the
cleaning products.
20
C l e a n i n g a n d m a i n t e n a n c e
Area
Stainless steel
Painted surfaces
Aluminium and
plastic
Glass
Controls
--------
Removing metal grease filter
Open the glass front slowly and fully. Hold the glass front in
1.
the centre when doing so, gripping it firmly.
Open the lock and swing down the metal grease filter. When
2.
you do this, take hold of the metal grease filter from
underneath with your other hand.
Take the metal grease filter out of the holder.
3.
Notes
Fat may accumulate in the bottom of the metal grease filter.
■
Hold the metal grease filter level to prevent grease from
■
dripping out.
Cleaning products
Hot soapy water:
Clean with a dish cloth and then dry with
a soft cloth.
Clean stainless steel surfaces in the
direction of the grain only.
Special stainless steel cleaning prod-
ucts are available from our after-sales
service or from specialist retailers.Apply
a very thin layer of the cleaning product
with a soft cloth.
Hot soapy water:
Clean using a damp dish cloth and then
dry with a soft cloth.
Do not use stainless steel cleaner.
Hot soapy water:
Clean with a soft cloth.
Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Hot soapy water:
Clean using a damp dish cloth and then
dry with a soft cloth.
Risk of electric shock caused by pene-
trating moisture.
Risk of damage to the electronics
caused by penetrating moisture. Never
clean controls with a wet cloth.
Do not use stainless steel cleaner.