Installation; Preparing For Installation - CONSTRUCTA CD688860 Gebrauchs- Und Montageanleitung

Installation

I n s t a l l a t i o n

Preparing for installation

Caution!
Ensure that there are no electrical wires, gas pipes or water
pipes in the area where holes are to be drilled.
If the extractor hood is to be operated in exhaust-air mode, a
flue duct must be fitted.
If the extractor hood is to be operated in air-recirculation mode,
an optional accessory must be fitted. To do this, refer to the
installation instructions provided. The flue duct does not need
to be fitted for air-recirculation mode.
Determine where the extractor hood should be positioned
1.
and lightly mark where the lower edge of the appliance
should be on the wall. Determine where the middle should be
based on the hob.
Note: We recommend fitting the extractor hood such that the
lower edge of the glass screen is in line with the lower edges
of the adjacent wall-hung cabinets. Make sure that the
specified safety clearances from the hob are complied with.
Place the template against the line drawn on the wall and
2.
fasten it in place. Mark where the screws should be inserted.
To fit the flue duct, the template must be cut along the
marked cut line.
Drill 8 mm diameter holes to a depth of 80 mm for fastening
3.
the appliance, remove the template and press in the wall
plugs flush with the wall.
27