Operating Modes; Operating The Appliance - CONSTRUCTA CD688860 Gebrauchs- Und Montageanleitung

Operating modes

Exhaust air mode
The air which is drawn in is cleaned by the
grease filters and conveyed to the exterior
by a pipe system.
Note: The exhaust air must not be conveyed into a functioning
smoke or exhaust gas flue or into a shaft which is used to
ventilate installation rooms which contain heat-producing
appliances.
Before conveying the exhaust air into a non-functioning
■
smoke or exhaust gas flue, obtain the consent of the heating
engineer responsible.
If the exhaust air is conveyed through the outer wall, a
■
telescopic wall box should be used.

Operating the appliance

These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
Note: Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel
Symbol Explanation
Fan on/off
#
1-3 Fan settings
P Intensive mode
Light on/off
6
Setting the fan
Switching on
Touch the # symbol.
The fan starts at fan setting 2.
Selecting the fan setting
Touch symbol 1, 2 or 3 to set a different fan setting.
Switching off
Touch the # symbol.
O p e r a t i n g m o d e s
O p e r a t i n g t h e a p p l i a n c e
Circulating-air mode
The air which is drawn in is cleaned by the
grease filters and an activated carbon filter
and conveyed back into the kitchen.
Note: To bind odours in circulating-air mode, you must install
an activated carbon filter. The different options for operating the
appliance in circulating-air mode can be found in the brochure.
Alternatively, ask your dealer. The required accessories are
available from specialist retailers, from customer service or
from the Online Shop.
Intensive setting
You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
Switching on
Touch the P symbol.
Note: After approx. 6 minutes, the extractor hood automatically
switches back to fan setting 3.
Switching off
If you want to end intensive mode before the preset time
expires, touch the P symbol.
Lighting
The lighting can be switched on and off independently of the
fan.
Touch the 6 symbol.
19