Installing Your Appliance; Before Connecting; Electrical Connection - Atag MC 4111 L Bedienungsanleitung

installing your appliance

before connecting

Warning:
Check that your appliance has not been damaged during transport (damage to door
or seal, etc.). If you notice any damage, contact your retailer before using the appliance.
In order to easily locate the reference information for your appliance, we recommend
that you note these data on the "After-Sales Service" page.

electrical connection

Check that:
- the electrical installation has sufficient vol-tage.
- the supply cables are in good condition
- the diameter of the wires complies with the installation requirements.
- your equipment has a protection of at least 16 amps.
If in doubt, contact your electrician.
The electrical connections should be made before the appliance is installed in its housing.
Electrical safety must be ensured through proper installation in the housing. During
installation and maintenance operations, the appliance must be unplugged from the
electrical grid; fuses must be cut off or removed.
The appliance must be connected using a (standardised) feeder cable with 3 conduc-
tors of 1.5 mm² (1 live + 1N + ground) which must be connected to the 220-240 V ~
monophase network using a CEI 60083-standardised 1 live + 1N + ground electrical out-
let or one which complies with installation requirements. The protection cable (green-
yellow) is connected to the appliance's
ance's ground.
If the connection is made with a plug, it must remain accessible after the appliance has
been installed.
The oven's neutral (blue cable) must be connected to the network's neutral.
Ensure your electrical installation has a system accessible to the user which can cut off the appli-
ance from the power grid, with a contact opening of at least 3 mm for all the terminals.
If the supply cable is damaged, it must be replaced by the manufacturer, its after-sales
service or any other similarly qualified person to avoid any danger.
Warning:
We cannot be held responsible for any accident resulting from an inexistent, defec-
tive or incorrect ground lead.
If the oven presents any irregularity, unplug the appliance or remove the relevant fuse at
the oven's connection lead-in.
92
terminal and must be connected to the appli-