FLEISCHMANN 18.4 Betriebsanleitung Seite 13

18 Long 0
addresses
29 Configuration Bit 0=0 Bit 0: With Bit 0 = 1 the direction of the
values
Bit 1=1 Bit 1: basic value 1 is valid for run ning the
Bit 2=1 Bit 2: With Bit 2 = 1 the recognition of
Bit 4=0 Bit 4: With Bit 4 = 0 the motor control
Bit 5=0 Bit 5: to utilise the long ad dres ses
60 Light dimming accor-
ding
to the
loco
66 Speed 0
adjustion,
forward
Lower section of long addresses.
Effective on DCC with CV29 Bit 5 = 1.
vehicle will be reversed.
decoder with 28 or likewise 128
speed steps. If the decoder is to be run
using 14 steps, then Bit 1 = 0 should
be set. The desired steps can be set
using the equipment.
analog power is switched on. With
Bit 2 = 0 pure digital operation is valid.
For operation layouts with mixed multi-
train languages, i.e. with TWIN-CEN-
TER, or while using analog braking
tracks (see "Braking") pure DCC must
be switched on.
characteristic line will be calculated by
CV's 2, 5, 6. With Bit 4 = 1 the control
line set in CV's 67 to 94 will be used
(DCC operation only).
128 to 9999, Bit 5 =1 should be set.
The value of this CV sets the
maximum intensity of the front lights.
0=off until 255=bright.
Numerical values from 1 to 255 to alter
the graduation of the control line for
running forward. Numbers larger than
128 will increase the speed, numbers
67 Modification of
to the regulation
94 characteristic
of the
control unit
95 Speed adjustion 0
backward
112 Configuration Bit 3=0 Bit 3=0: normal ( 4 functions for every
values
(only Motorola*)
266 Volume 65
267 Steam exhaust accor-
rhythm ding
to the
loco
lower than 128 decrease. With 0,
nothing more will happen.
A speed value between 0 and 255 can
be put into each of the 28 CV's from 67
to 94. In CV67 it's the lowest and CV94
it's the highest speed. The intermediate
settings give the control characteristic
line. It determines how the vehicle
speed alters in relation to the controller
settings. This control line is active with
CV29, Bit 4 = 1.
Same as CV66, but for backward
running.
address).
Bit 3=1: the following address will be
used for 4 additional functions. There
are 8 functions availabe now for this
loco.
The volume of the sounds can be set in
steps from 0=low up to 255=loud.
The value of this CV sets the
distance between the exhaust beats
and is relevant to the
of locomotive. Should the steam
exhaust beat of your loco not be
exactly synchroni sed even though
set at the maximum effect by the fac-
tory, it can be corrected here. Higher
values give higher pauses and vice-
versa.
type
11