Installation And Attachment - Siemens SIMATIC NET CP 1411 Installationsanleitung

Installation Instructions CP 1411
2.2

Installation and Attachment

Procedure Follow the steps below when installing and connecting the CP 1411:
Step
1 Turn off your computer and unplug the power supply connector.
2 Open the computer casing as described in the manual of your PC/programming de-
vice.
3 Remove the cover of a free 16-bit expansion slot on your computer.
4 Remove the CP 1411 from its packing.
When handling the module avoid touching the gold-plated connectors and
electronic components.
5 Plug the CP 1411 into the expansion slot and secure the front panel of the CP 1411
using the screw that held the cover in place.
Make sure that the CP 1411 is securely fixed and sits uniformly in the receptacle of
the expansion slot.
6 Close the computer casing as described in the manual of your PC/programming
device.
7 Plug in the power connector again but do not switch on your computer yet.
8 Plug the connecting cable (TP, AUI or ITP) into the appropriate female connector on
the front panel of the CP 1411.
32
All manuals and user guides at all-guides.com
Procedure
Installationsanleitung CP 1411
C79000-Z8974-C24-05