Selecting Desired Assistance Level - Gazelle Makki Benutzerhandbuch

38
•
Press the battery on/off button
The LEDs of the charge indicator
indicate the charge status.
" " If the battery capacity is less than 5%,
REMARK
no LED of the charge status will light up on the
battery. Only the on-board computer will then
indicate whether the drive unit is switched on.
2. Set the assistance level: See 'Selecting desired assistance
level', section 3.7.2 (page 38).
The drive unit is activated as soon as you start pedalling. The
motor power depends on the assistance level that has been
set on the on-board computer.
" " The Walk Assist function is not
REMARK
activated via the pedals; see 'Walk Assist',
section 3.7.3 (page 39).
As soon as you stop pedalling or as soon as the speed rises
above 25 km per hour, the assistance of the drive system is
switched off.
The drive system is automatically activated once more as soon
as you start pedalling or when the speed gets below 25 km per
hour.
Switching off drive unit:
The drive unit can be switched off in two ways:
Makki
.
41
will light up and
42
3.7.2
On the on-board computer you can set how much assistance
the drive unit gives you when pedalling.
The assistance level can be changed at all times, even when
cycling.
The following assistance levels are available:
•
Press the on-board on/off button
•
Press the battery on/off button
" " If the bicycle has not moved for approx.
REMARK
10 minutes and no button on the on-board
computer has been pressed, the drive unit will
automatically switch off in order to save power.

Selecting desired assistance level

" " Before using the bicycle, please first
DANGER
read 'Cycling', section 3.10 (page 47).
•
: The motor assistance is switched off.
OFF
•
Just like an ordinary bicycle, it can only keep moving by
continuing to pedal.
•
The Walk Assist function cannot be activated in this
assistance level.
•
: Adequate assistance with maximum efficiency for max-
ECO
imum range.
.
51
.
41