Lighting; On-Board Computer; Switching Drive Unit On/Off - Gazelle Makki Benutzerhandbuch

3.6 Lighting

52
Switching on lights:
1. Press the button + for a moderate period of time
52
2. Check that both the front and rear lights are on.
" " Ensure that the front light does not
WARNING
obstruct the vision of other road users. The light
beam must not point directly forwards.
Switching off lights:
1. Press the button + for a long period of time.
52
The lights will switch off.

3.7 On-board computer

3.7.1

Switching drive unit on/off

" " Before using the bicycle, please first
DANGER
read 'Cycling', section 3.10 (page 47).
The drive unit may only be activated if the following conditions
have been met:
•
A sufficiently charged battery has been installed; see 'Using
the battery', section 3.3 (page 30).
•
The speed sensor has been connected correctly;
see 'Adjusting speed sensor', section 4.3.5 (page 56).
Switching on drive unit:
There are two possible ways for switching on the drive unit:
•
Press the on-board on/off button
The display of the on-board computer
Gazelle Makki Manual | 37
51
.
51
lights up.
4
Using the Makki