Tightening Torque - Panasonic EY6506 Bedienungsanleitung

5. When in any of the conditions that
battery pack is too cool, or the bat-
tery pack has not been used for a
long time, the charging lamp is lit. In
this case, charging takes longer to
fully charge the battery pack, than
the standard charging time.
If a fully charged battery pack is
inserted into the charger again,
the charging lamp light up. After
several minutes, the charging
lamp may flash quickly to indicate
the charging is completed.
6. If the charging lamp does not light
immediately after the charger is
plugged in, or if after the standard
charging time the lamp does not go
off, consult an authorized dealer.
NOTE:
When charging a cool battery pack
.LAMP INDICATIONS .LAMP INDICATIONS

.TIGHTENING TORQUE

.TIGHTENING TORQUE
The power required for tightening a bolt will vary, according to bolt material and
size, as well as the material being bolted. Choose the length of tightening time
accordingly.
Reference values are provided below.
(They may vary according to tightening conditions.)
Factors Affecting Tightening Torque Factors Affecting Tightening Torque
The tightening torque is affected by a wide variety of factors including the follow-
ings. After tightening, always check the torque with a torque wrench.
1) Voltage
When the battery pack becomes nearly discharged, the voltage decreases and
the tightening torque drops.
Downloaded from www.Manualslib.com
Red Flashing
Red Lit
Green Flashing quickly
Orange Lit
Orange Flashing
manuals search engine
(below 5°C (41°F)) in a warm place,
leave the battery pack at the place
and wait for more than one hour to
warm up the battery to the level of
the ambient temperature. Other-
wise battery pack may not be fully
charged.
Cool down the charger when charg-
ing more than two battery packs
consecutively.
Do not insert your fingers into con-
tact hole, when holding charger or
any other occasions.
CAUTION:
Do not use power source from an
engine generator.
Do not cover vent holes on the
charger and the battery pack.
Charger is plugged into the AC outlet.
Ready to charge.
Now charging
Charging is completed.
Battery pack is warm. Charging will begin
when temperature of battery pack drops.
Charging is not possible. Clogged with
dust or malfunction of the battery pack.
- 6 -