Panasonic EY6506 Bedienungsanleitung Seite 4

Read "the Safety Instructions" booklet
and the following before using.
. ADDITIONAL ADDITIONAL
SAFETY RULES SAFETY RULES
1) Be aware that this tool is always in
an operating condition, since it does
not have to be plugged into an elec-
trical outlet.
2) When drilling or driving into walls,
floors, etc., "live" electrical wires may
be encountered. DO NOT TOUCH
THE CHUCK OR ANY FRONT
METAL PARTS OF THE TOOL! Hold
the tool only by the plastic handle to
prevent electric shock in case you
drill or drive into a "live" wire.
3) If the bit becomes jammed, immedi-
ately turn the main switch off to pre-
vent an overload, which can damage
the battery pack or motor.
Use reverse motion to loosen
jammed bits.
4) Do NOT operate the Forward/
Reverse lever when the main switch
is on. The battery will discharge
rapidly and damage to the unit may
occur.
5) During charging, the charger may
become slightly warm. This is nor-
mal. Do NOT charge the battery for a
long period.
6) Use only a dry, soft cloth to wipe
the unit. Do NOT use a damp cloth,
thinner, benzine, or other volatile sol-
vents for cleaning.
7) When storing or carrying the tool,
set the Forward/Reverse lever to the
center position (switch lock).
8) Do not strain the tool by holding the
speed control trigger halfway (speed
control mode) so that the motor
stops.
9) Wear ear protectors when using the
tool for extended periods.
10) Young children should be supervised
to ensure that they do not play with
the appliance.
Downloaded from www.Manualslib.com manuals search engine
. ASSEMBLY ASSEMBLY
Attaching or removing bit Attaching or removing bit
NOTE:
When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center posi-
tion (switch lock).
1. Hold the collar of quick connect
chuck and pull it against the driver.
2. Insert the bit into the chuck.
3. The bit holder will return to its origi-
nal position when it is released.
4. Pull the bit to make sure it does not
come out.
5. To remove the bit, pull back on the
bit holder in the same way.
CAUTION:
If the bit holder does not return to its
original position or the bit comes out
when pulled on, the bit has not been
properly attached. Make sure the bit
is properly attached before use.
Attaching or removing Attaching or removing
battery pack battery pack
1. To connect the battery pack:
Insert the battery pack. It snaps into
place to indicate proper connection.
2. To remove the battery pack:
Press the two buttons on the sides
of the battery pack. Slide the battery
pack out of the tool body.
. OPERATION OPERATION
Switch and Forward / Reverse Switch and Forward
lever Operation lever Operation
(Forward ( ), Switch lock, Reverse ( ))
CAUTION:
Do not operate Forward/Reverse lever
until the bit comes to a complete stop.
Forward Rotation Switch Forward Rotation Switch
Operation Operation
1. Push the lever for forward rotation.
- 4 -
Reverse