Panasonic EY6506 Bedienungsanleitung Seite 5

2. Depress the trigger switch slightly to
start the tool slowly.
3. The speed increases with the amount
of depression of the trigger for efficient
tightening of screws. The brake oper-
ates and the bit stops immediately
when the trigger is released.
4. After use, set the lever to its center
position (switch lock).
Reverse Rotation Switch Reverse Rotation Switch
Operation Operation
1. Push the lever for reverse rotation.
Check the direction of rotation before
use.
2. Depress the trigger switch slightly to
start the tool slowly.
3. After use, set the lever to its center
position (switch lock).
CAUTION CAUTION
To eliminate excessive tempera ture
increase of the tool surface, do not
operate the tool continu ously using
two or more battery packs. Tool
needs cool off time before switching
to another pack.
For Appropriate use of For Appropriate use of
Battery pack Battery pack
Ni-MH Battery pack (EY9200)
Charge the Ni-MH battery fully be-
fore storage in order to ensure a
longer service life.
The ambient temperature range
is between 0°C (32°F) and 40°C
(104°F).
If the battery pack is used when
the battery temperature is below
0°C (32°F), the tool may fail to func-
tion properly. In that case, charge the
battery until charging is completed for
appropriate functioning of the battery.
When battery pack is not in use,
keep it away from other metal objects
like: paper clips, coins, keys, nails,
screws, or other small metal objects
that can make a connection from one
terminal to another.
Shorting the battery terminals togeth-
er may cause sparks, burns or a fire.
When operating with a Ni-MH bat-
Downloaded from www.Manualslib.com manuals search engine
tery pack, make sure the place is
well-ventilated.
Battery Pack Life
The rechargeable batteries have a lim-
ited life. If the operation time becomes
extremely short after recharging,
replace the battery pack with a new one.
Charging Charging
NOTE:
When you charge the battery pack for
the first time, or after prolonged stor-
age, charge it for about 24 hours to
bring the battery up to full capacity.
Battery charger (EY0110)
1. Plug the charger into the AC outlet.
NOTE:
Sparks may be produced when the
plug is inserted into the AC power
supply, but this is not a problem in
terms of safety.
2. Insert the battery pack firmly into
the charger.
Battry pack
3. During charging, the charging lamp
will be lit.
When charging is completed, an
internal electronic switch will auto-
matically be triggered to prevent
overcharging.
Charging will not start if the bat-
tery pack is warm (for example,
immediately after heavy-duty
operation).
The orange standby lamp will be lit
until the battery cools down. Charging
will then begin automatically.
4. When charging is completed, the
charging lamp will start flashing
quickly in green color.
- 5 -
To AC
outlet
Battery
charger