Settings; Cleaning, Care And Maintenance; Troubleshooting - AEG DDLT PinControl 13 Bedienung Und Installation

Operation
Heating system
The bare wire heating system has a pressure-tested
plastic casing. The heating system is suitable for hard
and soft water areas and is largely insusceptible to scale
build-up. This heating system ensures rapid and efficient
DHW availability.

4. Settings

2
1 Partial load
At low throughput 1/3 of the heating output is activat-
ed; at higher throughput 2/3 of the available heating
output is enabled. This setting is suitable for hand
washing at a basin, for example.
2 Full load
At a low throughput, 1/2 of the heating output is ap-
plied; at a higher throughput the full heating output is
activated. This setting is suitable for washing dishes,
for example.
» Click the output selector into the required position.
Recommended settings when using a
thermostatic valve
» Set the output selector to full power.
4.1 Recommended tap/valve settings
Note
If the outlet temperature is not sufficiently high at
full load and with the draw-off valve fully open, then
more water is flowing through the appliance than
can be heated by the heating system (appliance is
at its output limit).
» Reduce the water volume at the draw-off valve.
Low draw-off rate = high outlet temperature
High draw-off rate = low outlet temperature
Twin lever tap
Output stage
Partial load
Full load
» Add cold water if the temperature is too high when
the tap is fully open.
Mono lever mixer
Output stage
Full load
» Turn the tap lever to the highest temperature.
» Fully open the tap.
» Increase the outlet temperature by closing the tap
slowly.
» Reduce the outlet temperature by adding cold water
or opening the tap further, if possible.
18
1
Application range
Washbasin
Bath, sink
Application range
All
Following an interruption to the water supply
Material losses
!
Following an interruption of the water supply the ap-
pliance must be recommissioned by carrying out the
following steps, in order to prevent the destruction
of the bare wire heating system.
» Disconnect the appliance from the power sup-
ply by removing the fuses/tripping the MCBs.
» Open the tap for one minute until the appliance
and its upstream cold water inlet line are free of
air.
» Switch the mains power back on again.
5. Cleaning, care and
maintenance
» Never use abrasive or corrosive cleaning agents. A
damp cloth is sufficient for cleaning the appliance.
» Check the taps regularly. Limescale deposits at the
tap outlets can be removed using commercially avail-
able descaling agents.

6. Troubleshooting

Problem Cause
The appliance will not There is no power.
start despite the DHW
valve being fully open.
The flow rate is too
low for switching on
the heating output.
The aerator in the tap
is scaled up or dirty.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate (000000-0000-00000):
Remedy
Check the fuses/
MCBs in your fuse
box/distribution board.
Clean and/or descale
the aerator.
Nr.: 000000-0000-00000