Possible Faults; Technical Data; Possible Cause - ATIKA KGS 210 N Originalbetriebsanleitung

Possible faults

Before each fault clearance
 Switch off device
 Wait for standstill of the saw blade
 Pull out power plug

After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start
after switching on or
switches off during idle
running
No crosscut function
Machine stops while
cutting
Burned spots at the cut
areas
Saw vibrates
Chip outlet is clogged
Rotary table moves hard

In case of further faults or inquiries please contact your local dealer.

Technical data

Model / Type
Year of constructions
Motor output P
1
Mains voltage
Mains frequency
No-load speed
Saw blade diameter
Saw blade hole
min. tooth width
Mitre left/right
Incline angle left
Max. cross-section of work piece (height x width)
Straight cuts:
Mitre cuts (rotary table 45°)
Inclined cuts (saw head 45° to the left)
Double mitre cuts (rotary table 45°/saw head 45°)
Exhaust connection
Dimensions (length x breadth x height)
Weight approx.
Commercial chip exhaust system or industrial vacuum cleaners can be used for exhaustion.
16

Possible cause

 Power failure
 Extension cable defect
 Motor or switch defect
 Transport locking pin not removed
 Locking device for pendulum cover not opened
 Saw blade is dull
 Feed is too great
 Saw blade is not suitable for the work step or
is dull
 Saw blade is warped
 Saw blade not properly mounted
 No exhaust system connected
 Exhaust power too weak
 Chips under rotary table
Removal
 Check safety fuse
 Check cable, no longer use defect cable
 Have motor or switch checked by an approved elec-
trician or replaced by original spare parts
 Pull out transport locking pin (5)
 Open locking device (17)
 Replace saw blade (16)
 Allow motor to cool and proceed working with less
pressure
 Replace saw blade
 Replace saw blade
 Mount saw blade properly
 Switch off saw, remove chips and connect exhaust
system
 Switch off saw, remove chips and increase exhaust
power (air velocity 20 m/sec at chip exhaust neck.
 Remove chips
KGS 210 N
see last page
1400 W
230 V~
50 Hz
5000 min
–1
 210 mm
 25,4 mm
2,8 mm
0-45 °
0-45°
50 x 120 mm
50 x 80 mm
30 x 120 mm
30 x 80 mm
 38 mm
260 x 390 x 380 mm
6,2 kg
Technical modifications reserved!