Safety Instructions; Spare Parts / Description; Preparing For Commissioning - ATIKA KGS 210 N Originalbetriebsanleitung

In addition, in spite of all the precautionary measures taken,
non-obvious residual risks can still exist.

Safety instructions

Read all safety warnings and all instruc-
tions. Failure to follow the warnings and instructions may result
in electric shock, fire and/or serious injury.

For safety instructions, please refer to the enclosed bro-
chure "Safety instructions for crosscut and mitre saws".
Keep the instructions in a safe place for future use.
Spare parts /
Description of device
 Please refer to the attached assembly and oper-
ating instruction sheet.
Pos. Order-no.
1 363491 Lock for pendulum cover
2  Circuit closer/breaker
3  Handle
4  Motor
5  Transport locking pin
6 363478 Fixing screw for rotary table
7 363624 Work piece stop
8  Rotary table
9  Base plate
10  Scale for mitre angle
11 363482 Set screw for 45° saw head incline
12 363482 Set screw for 90° saw head position
13 363475 Hex wrench (SW4)
14 363480 Hex wrench (SW6)
15 363499 Protective cover
16 363495 Saw blade, 210 x 25,4 x 2,8 mm – 24 T
17 363493 Pendulum cover
18 363481 Locking screw for work piece stop
19  Scale for incline angle
20 363486 Incline fixing knob
21 363490 Dust bag
22  Exhaust neck
23  Locking nut for set screw
24  Indicator for incline angle
25 363485 Saw blade locking device
Hexagon socket screw for saw blade
26 363498
mounting
27 363496 Front saw blade flange
28 363494 Rear saw blade flange
29 363497 Washer
31  Carrying handle
32 363502 Safety label
33 363488 Carbon brushes
34 363473 Vise assembly
35  Mounting screw for the pendulum cover
36  Anti-tip device
12
Designation

Preparing for commissioning

 To achieve flawless functioning of the machine, please
follow the instructions listed:
 Place the machine at a location that meets the following
conditions:
 secured against slipping
 free of vibrations
 even
 free of tripping hazards
 adequate light
 Before each use, check
 Connection cables for defects (cracks, cuts, etc.)
Do not use any defective cables.
 the table insert for proper condition
Immediately replace a worn or damaged table insert.
 the saw blade for flawless condition
Do not use deformed or damaged saw blades.
 Connect the machine to a dust collection device when
sawing wood.
 To ensure a safe position of the saw it must be bolted down
on a solid surface (e.g. workbench or support frame) at opti-
mal working height:
Mounting on a workbench / work table
Place the device on a level flat workbench or work table.

An uneven surface may result in saw blade jamming
or inaccurate cutting.
Make 4 holes in the workbench / work table matching the
holes in the base plate (9).
 Disengage the transport locking pin

Make 4 holes in the support matching the holes in the
base plate.
 Bolt the device down.
Removing the transport locking pin
Loosen the transport locking pin before first use and after each
transport:
Slightly push the handle (3) down
Pull out the transport locking pin (5)
Anti-tip device
If the saw cannot be mounted on a workbench or
work table, insert the anti-tip device (40) in the provided
holes on the rear of the rotary table. Secure it using two
screws.