Commissioning; Adjusting The Saw - ATIKA KGS 210 N Originalbetriebsanleitung

Commissioning

Mains connection
Compare the voltage listed on the device type plate, e.g. 230 V,
with the mains voltage and connect the device to the corre-
sponding and proper socket.
Connect the machine via a 30 mA fault-current circuit breaker.
Use the connection or extension cable according to IEC 60245
(H 07 RN-F) with a core cross-profile section of at least
1.5 mm for cable lengths up to 25 m

2
2.5 mm for cable lengths over 25 m

2
On / Off Switch
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired or
replaced immediately by the customer service.
Switch on
Activate the On/Off switch (2).
Switching off
Release the On/Off switch again.
Dust/chip exhaustion
The wood dust generated during operation impedes
the necessary view and is harmful to health to some
degree.
Unless the machine is used outdoors, the dust bag (21) or a
chip exhaust system must be connected.
Make sure that the connections for the dust extraction
and the dust bag (collecting device) are connected and
used correctly.
Dust bag

When using the dust bag:
push the dust bag (21) onto the exhaust neck (22).
regularly empty the dust bag
Chip exhaustion
Connect a chip exhaust system with suitable adapter to the
chip exhaust neck (22) (dia. 40 mm).

Air velocity at the exhaust neck of the saw ≥ 20 m/sec
Use a special exhaust device when exhausting dusts
that are especially harmful to health, carcinogen or
dry.
Vise assembly (34)
Always secure work pieces to be handled. Do not cut
work pieces that cannot be secured with the vise assembly.
The vise assembly can be positioned to the left or right of
the saw head.
Insert the vise assembly (34) at the right or left into the
hole provided.
Secure it with the wing screws.
Press the work piece firmly against the work piece stop (7).
Turn the machine knob of the vise assembly clockwise.

Adjusting the saw

Before setting operations
 Switch off device.
 Wait for standstill of the saw blade

Pull out power plug
Setting the work piece stop

To adjust a work piece stop that has shifted during
transport, proceed as follows:
Set the rotary table (8) to the 0° position and tighten the
fastening bolts for the rotary table (6) (see "Straight cuts").
Position the saw head in transport position (see
"Transport")
Check the angle between saw blade and work piece stop
using a square (A, not supplied).
Loosen the locking screw for the work piece stop if the
work piece stop (18) needs to be adjusted
Align the work piece stop along the square and tighten the
locking screw again.
Adjusting the incline of the saw head

Also check the angle of the saw head to the rotary table.
Check the angle with a square (A, not supplied) or protrac-
tor.
Proceed as follows if the angle is not exactly 90°:
First loosen the incline locking knob (20) and turn the saw
head slightly to the side.
Then loosen the locking nut (23) for the set screw (12)
Turn the set screw (12) back to reduce the angle be-

tween saw head and rotary table.
Turn the set screw (12) forward to reduce the angle

between saw head and rotary table.
Tighten the locking nut for the set screw once more.
If necessary, loosen the screw for the indicator (24) and
shift it until it points to "0". Tighten the screw again.
Tilt the saw head by 45° and verify the angle with a pro-
tractor (B).
If necessary, adjust the incline angle of the saw head with
the help of the set screw (11).
13