Transport; Storage; Guarantee - ATIKA KGS 210 N Originalbetriebsanleitung


Use for instance sewing machine oil, liquid hydraulic
fluid or environmentally acceptable spray oil.
 Take care that the saw blade remains free of rust and resin.
 Remove resin residues from the surface of the rotary table.

Resin residues can be removed with a commercial
maintenance and care spray.
 The saw blade is a wearing part and will become dull after
prolonged or frequent use.

Replace the saw blade in that case.
 Thoroughly shake out the dust bag. Wash the dust bag in
case of heavy soiling but at least once a year with a mild
soap solution.
Maintenance
Changing the saw blade
Danger of cutting! Wear gloves when replacing the
saw blade.
If possible, carry saw blades in a container.

Use only suitable saw blades.
Danger of burning! The saw blade is still hot shortly
after cutting.
Position the saw head in transport position.
Push the saw blade locking device (25).
Slowly turn the saw blade by hand until the saw blade lock-
ing device catches.
Unscrew the hexagonal screw (26) for the saw blade (left-
handed thread!)
Loosen the transport locking pin (5) and turn the saw head
up again.
Unscrew the mounting screw (35) for the linkage of the
pendulum cover (17) to push up the cover after the lock (1)
has been actuated.
You can now remove the front saw blade flange (27), the
saw blade (16) and the rear saw blade flange (28).

Clean the saw blade flanges (27, 28).
Position the rear saw blade flange again.
Insert a new saw blade.

Pay attention to the correct running direction of the
saw blade: The arrow on the saw blade and the arrow on
the protective cover must point in the same direction!
Position the front saw blade flange again.
The further assembly is now done in reverse sequence.
Please be sure to note: Before tightening the hex-
agon head screw (26) for the saw blade, push in the
saw blade locking device (25)
Replacing the carbon brushes
Replace the carbon brushes once they have been worn down to
approx. 4 mm.
Remove the carbon brush cover on the side of the motor
cover by turning it counterclockwise using a suitable screw
driver.
Remove the carbon brushes; note the position of the
spring retention.
Insert the new carbon brushes (33) observing the correct
position of the spring retention.
Replace the carbon brushes only in pairs.
Screw in the carbon brush cover again.

Transport

Remove mains plug before each transport.
Before each transport:

 Position saw head vertically
 Turn rotary table to 0°
 Push handle (3) down and engage the transport locking
pin (5)
 Carry the saw on its transport handle (2).
Do not transport or lift the machine by its protective
devices.

Storage

Remove the mains plug from the socket.
 Store unused equipment in a dry, locked place out of the
reach of children.
 Before extended storage, please observe the following to
increase the service life of the device and to ensure smooth
operation:
 thoroughly clean the saw
 treat all movable parts with an environmentally friendly oil

Never use any grease!

Guarantee

Please observe the enclosed terms of guarantee.
15