Fitting The Speed Kit; Fitting The Semi Rigid Carbon Seat Board - SKY PARAGLIDERS SKYLIGHTER 4 M Bedienungsanleitung

2.3. Fitting the speed kit
• Set Up
Route the speed bar line first through the eyelet at the front
of the seat part (photo 1), then through the pulley on the side
(photo 2) and finally out through the elastic fairing.
2.4. Fitting the semi-rigid carbon seat
board
The carbon seat board is not delivered with your harness. This
is an optional item.
• Speed System Adjustment
The speed system should be adjusted to the correct length
using a harness simulator.
1
Before you install your seat board you must take out the back
foam protection. It will make your installation easier.
SKYLIGHTER 4
User manual / Handbuch
2
1
The pocket of back foam protection you will find under the seat.
Open the zipper of the pocket.
3
2
15