Specifications & Technical Data; Tool Specifications; Fastener Specifications - Max CN238D Betriebsanleitung

2. SPECIFICATIONS AND TECHNICAL DATA
1. NAME OF PARTS
②
①
④
③

2. TOOL SPECIFICATIONS

HEIGHT
WIDTH
LENGTH
WEIGHT
RECOMMENDED
OPERATING PRESSURE
LOADING CAPACITY
AIR CONSUMPTION
TOOL AIR FITTINGS:
This tool uses a 6 mm (1/4˝) N.P.T. male plug. The inside diameter should be 7 mm (.28˝) or larger. The fitting must be capable of
discharging tool air pressure when disconnected from the air supply.
RECOMMENDED OPERATING PRESSURE:
4 to 8 bar (60 to 120 p.s.i.). Select the operating air pressure within this range for best fastener performance.
DO NOT EXCEED 8 bar (120 p.s.i.).
4. TECHNICAL DATA
q NOISE
A-weighted single-event ------ LWA, 1s, d 88.7 dB
sound power level
A-weighted single-event ------ L p A , 1s, d 81.1 dB
emission sound pressure
level at work station
These values are determined and documented in accordance to EN12549:1999+A1:2008.
NOTE: These values are tool-related characteristic values and do not represent the noise generation at the point of use. Noise
at the point of use will for example depend on the working environment, the workpiece, the workpiece support, and the number
of driving operations. In addition, reference should be made to noise reduction measures.
NOTE: Workplace design can also serve to reduce noise levels, for example placing workpieces on sound-damping supports
(see also ISO11690-1).
w VIBRATION
Vibration characteristic value ＝ 3.09 m/s
These values are determined and documented in accordance to ISO 28927-13
NOTE: The vibration emission value above is a tool-related characteristic value and does not represent the influence to the
hand-arm-system when using the tool. Any influence to the hand-arm-system when using the tool will for example depend on
the gripping force, the contact pressure force, the working direction, the adjustment of energy supply, the workpiece, the
workpiece support.
5. APPLICATIONS
＊General constuction works
＊Furniture assembly including drawer assembly, case back nailing
＊Cabinet assembly
＊Interior and exterior triming
＊Flooring
⑨ ⑥ ⑦ ⑧
⑤
249 mm (9-7/8˝)
106 mm (4-3/16˝)
217 mm (8-1/2˝)
1.2 kg (2.6 lbs.)
4 to 8 bar (60 to 120 p.s.i.)
200 Nails
0.5Rat 6 bar (90 p.s.i.)
operating pressure
2
q Frame
w Cylinder Cap
e Contact Arm
r Nose
t Magazine
y Trigger
u Grip
i Exhaust
o Trigger Lock Dial

3. FASTENER SPECIFICATIONS

NAIL LENGTH
SHANK DIAMETER
SHANK TYPE
HEAD DIAMETER
7
PLASTIC SHEET COLLATED
17 to 38 mm (11/16˝ to 1-1/2˝)
φ1.47 to φ2.0 mm (.058˝ to .079˝)
Smooth, Ring, Screw
φ3.1 to φ5.0 mm (.122˝ to .197˝)