Phonak SafetyMeter Gebrauchsanweisung Seite 25

7 "System check" mode
Press both headphone cups together. This is most easily achieved when the headphone
band is fully extended.
Start the test. If "System check 1" is not successful follow the on-screen instructions.
7.4 "System check 2" screen
Place the probes in the corresponding openings of Check disc 2 as
explained in the on-line help. When Check disc 2 is correctly positioned,
the probes will sit as shown on the right:
Press both headphone cups together. This is most easily achieved when the headphone
band is fully extended.
Start the test. If "System check 2" is not successful follow the on-screen instructions.
19
004 mode emploi.indd 19 24.6.2010 15:33:40