Phonak SafetyMeter Gebrauchsanweisung Seite 22

7 "System check" mode
The software automatically suggests a system check every 6 months. When a system
check (for a specific probe) is necessary the below message appears at start-up.
This message appears every time SafetyMeter starts-up, up to a maximum of 5 times for
each probe.
Each time this message is displayed, the warnings counter of the probe decreases (see
paragraph 7.2).
7.1 Main screen of "System check" mode
The left-hand buttons follow the system check test sequence
To go to the next step, click the "right arrow" button
the "left arrow" button or Page Up on your keyboard to return to the previous page.
On-line help is available for each screen by clicking the "?" button at the bottom left of
the screen .
t
7.2 Probe screen
All available probes are listed in the middle frame. The date when these were last checked
is given, as well as their status
Once a probe has been successfully checked its status is marked Ç. It can then be used in
attenuation control mode.
16
004 mode emploi.indd 16
or Page Down on the keyboard. Click
r
.
u
.
e
24.6.2010 15:33:40