Phonak SafetyMeter Gebrauchsanweisung Seite 13

3 Installation
u Connect the headphone cable to the HEADSET socket of the soundcard.
Check that the cable is properly attached to the headphones' cups: the blue
connector must be plugged into the cup with the L mark. The red connector must
be plugged into the R cup.
Select the probe you are going to use first. Plug it into the PROBE socket of the soundcard.
The software will issue a warning message if the headphones and probe have been
wrongly connected to the soundcard.
7
004 mode emploi.indd 7
u In the
"Playback"
menu, select
the Phonak
PAC Speakers.
u In the
"Recording"
menu, select
the Phonak
PAC Line.
24.6.2010 15:33:37