Adjustments; Temperature Setting Of Plates; Contact Time Setting Between Plates; Thickness Setting - Moretti Forni iP 33 Bedienungsanleitung

• The displays of thermoregulators A and B (Pict.3.1) lights up and show the instantaneous
temperatures of upper and lower plates respectively.
• The lights A1 and B1 light up (Pict.3.1) and show the ignition of the upper and lower
plate resistance which, by thermal effect, start the heating phase.
• Timer D lights up and show the set contact time
4.3

ADJUSTMENTS

The recommended settings are purely indicative and depend on the following variables: the
dough, the weight, the thickness, the size and the shape of the disk.
The correct adjustment of the machine must be made experimentally

4.3.1 TEMPERATURE SETTING OF PLATES

To set the upper plate temperature, press button H (PICT. 3.2) of thermoregulator A (PICT. 3.1).
To set the desired temperature, press the I or L button to increase or decrease the temperature
respectively; press H button again to confirm the value of temperature.
Proceed in the same way with the thermoregulator B (PICT. 3.1).
When the upper and lower plates reach the set temperature values, the A1 and B1 lights will
turn off.
To optimize the shaping of the dough and the non-stick effect of the disks, it's necessary that
the temperature of these is always constant on 140°-150° C (the time needed for the
stabilization is about 15 minutes from the moving down).
INFORMATION
The temperatures of the plates set during the working cycle is automatically stored and
resumed when the machine is switched on

4.3.2 CONTACT TIME SETTING BETWEEN PLATES

To set contact time between plates press button D1 (PICT. 3.1). It's possible to set a contact
time between two plates from 0 to 9 sec.
The display D (PICT. 3.1) show the set time.

4.3.3 THICKNESS SETTING

The machine is provided with a medium (about 1 mm) size regulation for the shapes of pizza.
With this machine you can have different thicknesses of dough to suit all requirements by just
turning the regulating knob F (PICT. 4.1).
In particular:
To reduce the thickness (-): rotate the F knob counterclockwise
To increase the thickness (+): rotate the F knob clockwise
UK/13