Cleaning And Maintenance - Concept ZV1000 Bedienungsanleitung

EN
EN
USE
Before putting the appliance in operation, choose a suitable place for it - a stable, flat surface. To ensure proper air
circulation, it should be placed at least 15 cm away from walls and other objects. Place the unit on a waterproof surface
so water does not damage the furniture or the floor.
Do not place it directly on carpet, towels, blankets or other absorbent surfaces. The manufacturer is not responsible
for damage to property caused by water leakage.
Filling the water tank with water
Ensure that the appliance is disconnected from the mains.
1. Remove the tank from the base of the appliance.
2. Turn the tank upside down and turn the cap counterclockwise.
3. Pour clean cold water into the tank. Only pour water into the tank.
4. Close the tank by turning the cap clockwise. Ensure the cap is tighten properly.
5. Put tank back to the base of the appliance.
NOTE: Make sure the tank is filled with water prior to putting the appliance in operation.
1.
3.
46
58
2.
4.
On/Off button
The on/off button functions also as a control button for fog intensity as well as optional night lightning:
• Press the button once: low steam output, night lightning off
• Press the button second time: low steam output, night lightning on
• Press the button third time: high steam output, night lightning on
• Press the button fourth time: high steam output, night lightning off
The blue backlit of the on/off button indicates proper operation of the appliance. About 10 seconds after setting the
desired mode, the blue backlit turns off automatically. When water content runs out, the red indicator lights up and
the appliance switches off. Simply refill the water tanks and continue operation.

CLEANING AND MAINTENANCE

Cleaning brush
The package includes a cleaning brush for cleaning the ultrasonic disk from dust and other dirt.
General cleaning instructions
• Before manipulating with the appliance, disconnect it from the mains first.
• Internal part of the appliance: Drain excess water from the tank. Wash the unit with clean water and if necessary,
use a cleaning brush and a soft cloth. Do not immerse the base of the appliance in water and prevent water from
entering the dry air outlet of the appliance.
• Water tank: Empty the water tank. Remove the nozzle and clean the tube with clean water and a bottle cleaning
brush (not included in the package).
• External surface of the appliance: Wipe the outside of the appliance with a soft, damp cloth if needed. If water
starts condensing on the surface of the appliance during operation, reduce the power of the humidifier and wipe
the appliance.
Decalcifying
• Depending on the frequency of use and water hardness, it may be necessary to decalcify each or every second
week in order to optimize the performance of the appliance.
• If you live in a hard water area, we recommend using distilled water to help reduce the build-up of minerals.
• Do not clean the unit or the water tank with aggressive detergents or chemicals. You can use a decalcification
cartridge or cleaning tablets for humidifiers to keep the water tank free of deposits.
Ultrasonic disk
1. Disconnect the appliance from the mains.
2. Remove the water tank and drain all the water from the base and the tank.
3. Locate the ultrasonic disk according to the figure below.
4. Use the cleaning brush included in the package to gently clean the ultrasonic disk from deposits.
NOTE: Do not damage the ultrasonic disk in any way.
ZV1000 ZV1000 ZV1000
ZV1000 ZV1000
To clean the disk, use the brush only.
Do not use anything other than that.
ultrasonic disk
EN
EN
47
59