Operation - Unold 58550 Bedienungsanleitung

8. Insert the provided handles (without picture) in the grill housing insert (part
no. 5) by pressing them from below in the respective groove, until the clutch
engages.
9. A sure transport of the device is guaranteed by the handles.
10. Place the water tray (3) onto the opening in the insert. Please ensure that
the two openings on the water tray face upwards on the insert as a recess for
the heating element (2).
11. Ensure that the grill table is stable.
Fill the water tray with at least 1300 ml of water (max. 2.000 ml).
Never operate the grill without first filling the water tray.
12. Insert the heating element (2). The insert is correspondingly recessed for
the control unit. Please insert the heating element very firmly, as otherwise
the built-in safety switch on the lower side of the control unit prevents the
appliance from being switched on.
13. Place the grill grate (1) into position.
14. Check to make sure that all parts have been assembled correctly.
15. Connect the appliance via the power cable to the power supply (AC, 230 V~,
50 Hz).

OPERATION

1. Prepare the appliance as described in the section "Assembly and prepara-
tion for operation".
2. Check to make sure that all parts have been assembled correctly, and that
the grill table is stable.
3. For safety reasons, the appliance may be used indoors only as a table grill.
The appliance may be used as a free-standing grill only in a protected area
out of doors.
4. Connect the appliance via the power cable to the power supply (AC, 230 V~,
50 Hz).
5. Use the rotary knob to set the desired temperature.
6. When the required temperature has been reached, you can start grilling.
7. The first time you use the appliance, it is possible that there will be some
smoke.
8. The water in the water tray may also produce a small amount of steam. The
water prevents the surface under the grill from exposure to excessive tem-
peratures.
Stand 21.2.2020
Copyright UNOLD AG | www.unold.de
DE
EN
FR
NL
IT
ES
PL
23 von 80