Troubleshooting; Possible Cause - Scheppach MST254 Original Bedienungsanleitung

14. Troubleshooting

Fault

Possible cause

Motor does not work Motor, cable or plug defective, fuses burnt
The motor starts Voltage too low, coils damaged, capacitor
up slowly and does burnt
not reach operating
speed.
Motor makes exces- Coils damaged, motor defective
sive noise
The motor does not Circuits in the network are overloaded
reach its full power. (lamps, other motors, etc.)
Motor overheats Overloading of the motor, insufficient cool-
easily. ing of the motor
Saw cut is rough or Saw blade dull, tooth shape not appropri-
wavy ate for the material thickness
Workpiece pulls Excessive cutting pressure and/or saw
away and/or splinters blade not suitable for use
www.scheppach.com / service@scheppach.com /
Remedy
Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Contact an electrician to check the voltage.
Arrange for inspection of the motor by a spe-
cialist. Arrange for replacement of the capaci-
tor by a specialist
Arrange for inspection of the motor by a spe-
cialist
Do not use any other equipment or motors on
the same circuit
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Re-sharpen saw blade and/or use suitable saw
blade
Insert suitable saw blade
+(49)-08223-4002-99 / +(49)-08223-4002-58
GB | 35