Activating The Timer; Changing The Stop And Restart Temperatures - Steinbach Waterpower 5000 Bedienungsanleitung

4. Repeatedly press the Mode button
The Cooling indicator
Setting the temperature
1. Repeatedly press the Down button
After the temperature is set, it can take up to 3 minutes until the heat pump starts
up.
The Temperature 1 display

Activating the timer

The adjustable range of the timer is 1 – 24 hours. The delayed operating mode can only
be activated in standby mode and the delayed standby mode can only be activated in
operating mode.
Activating the delayed operating mode
1. Press and hold the ON/OFF button
The Timer display
2. Repeatedly press the Down button
The Timer display
pump in hours.
Activating the delayed standby mode
1. Press and hold the ON/OFF button
The Timer display
2. Repeatedly press the Down button
The Timer display
pump in hours.

Changing the stop and restart temperatures

1. Put the heat pump into standby mode (see "Display" section).
2. Press and hold the ON/OFF button
The stop and restart temperatures appear on the display.
3. Repeatedly press the Down button
The selectable temperature range for the stop temperature is -15 – 97 °C.
The Temperature 1 display
4. Press the ON/OFF button
appears. The heat pump is in cooling operating mode.
19
shows the desired water temperature in °C.
24
appears.
22
shows the time until the next desired start of operation of the heat
22
appears.
22
shows the time until the next desired end of operation of the heat
22
shows the desired stop temperature.
24
.
18
.
17
or the Up button
15
for about 3 seconds.
18
or the Up button
15
for about 3 seconds.
18
or the Up button
15
for about 3 seconds.
18
or the Up button
15
.
16
.
16
.
16
.
16
61