Setting Up The Heat Pump; Connecting The Lines; Display; Standby Mode - Steinbach Waterpower 5000 Bedienungsanleitung

Setting up the heat pump

Installing the heat pump at its setup location
1. Place the heat pump on the ground anchors at the prepared setup location.
Take care to align the connections and the display in the intended direction.
2. Screw the feet of the heat pump hand-tight to the ground anchors.
The heat pump is installed at the setup location.

Connecting the lines

Connecting the water lines
1. Clean large-particle soiling from the connection points of the heat pump
adapters on the hose ends of the water lines.
2. Screw the drain line onto the outlet water connection
3. Screw the supply line onto the inlet water connection
The water lines are connected.
Establishing the power supply
1. Connect the power plug at the end of the power cable
prepared at the setup location.
All display elements of the display
The power supply is established.
Connecting a drain line for condensation water (optional)
1. Insert the drain connection piece
2. Attach the drain line (garden hose) for condensation water to the drain connection
piece .
5
The drain line for condensation water is connected.

Display

Standby mode

In standby mode, the heat pump is ready for operation but it is deactivated. The water is
neither being heated nor cooled. Press the ON/OFF button
between standby mode und operating mode.
light up.
C
into the hole in the base plate.
5
.
6
.
8
to the power supply
9
to switch the heat pump
18
and the
1
55