Steinbach Waterpower 5000 Bedienungsanleitung Seite 47

- Only start work on the heat pump after checking all safety
regulations.
- Work on the heat pump must only be performed when it is de-
energised.
- Only connect the heat pump if the mains voltage from the power
socket matches the voltage indicated on the rating plate.
- Only connect the heat pump to an easily accessible power socket
so that in the event of a malfunction, you can quickly disconnect
the heat pump from the mains.
- Do not operate the heat pump if there is visible damage or the
mains cable or the mains plug is defective.
- If the mains cable of the heat pump is damaged, it must be
replaced by the manufacturer, the manufacturer's customer
service or a similarly qualified person in order to avoid hazards.
- Do not open the housing. Leave repairs to qualified specialists.
Liability and warranty claims are excluded in the event of repairs
carried out on your own, improper connection or improper
operation.
- Only parts that correspond to the original device specifications
may be used for repairs. This heat pump contains electrical and
mechanical parts that are essential to protect against hazard
sources.
- Do not operate the heat pump with an external timer switch or a
separate remote control system.
- Do not submerge the heat pump, the mains cable or the mains
plug in water or any other liquid.
- Never touch the mains plug with damp hands.
- Never pull the mains plug out of the power socket by the mains
cable. Instead, always grasp the mains plug.
- Never use the mains cable as a carrying handle.
- Keep the heat pump, the mains plug and the mains cable away
from naked flames and hot surfaces.
47