Installation; Installing Adapters On The Hose Ends - Steinbach Waterpower 5000 Bedienungsanleitung

Installation

Installing adapters on the hose ends

1
3
If a filter system is used, it must be connected upstream of the heat pump so
that the filtered water flows through the heat pump.
1. Use a hose clamp to attach the hose fitting
Fig. 1).
2. Place the union nut
3. Push the seal
out one thumb width.
4. Use a hose clamp to attach the hose fitting
Fig. 1).
5. Place the union nut unto the hose fitting
6. Push the seal
out one thumb width.
The adapters are installed on the hose ends.
54
2
unto the hose fitting
2
onto the hose fitting
3
onto the hose fitting
3
4
to the hose end of the supply line (see
4
.
4
far enough so that the end of the pipe sticks
4
to the hose end of the drain line (see
4
.
4
far enough so that the end of the pipe sticks
4