Activating Heating; Showing Or Setting Parameters - Steinbach MINI Bedienungsanleitung

Testing the residual current circuit breaker
1. Connect the RCD power plug to the power supply prepared at the setup location.
2. Press the RESET button.
The LEDis lit. The heat pump is supplied with power and is in standby mode.
3. Press the TEST button.
The LEDgoes off. The heat pump is disconnected from power and the display goes off.
4. Press the RESET button.
The LEDis lit. The heat pump is supplied with power and is in standby mode.
The residual current circuit breaker of the RCD power plug has been tested successfully.

Activating heating

The adjustable temperature range in operating mode is between 15 to 35°C. The start value of the set
water temperature is 27°C.
The water in the pool is heated up fastest at maximum throughput of the water through
the heat pump (see section "Technical data"). However, increasing the flow rate reduces
the time spent at the heat exchanger, which means that the difference in temperature
between the water in the pool and the heated water at the pool inlet is lower overall and
therefore less noticeable. Please measure and record the change in the current water
temperature every 30 minutes to determine the actual heating of the pool water.
Activating operating mode
1. Press the RESET
12
The LED is lit. The heat pump is supplied with power and is in standby mode.
11
2. Press the ON/OFF button
The heat pump is in operating mode and the display
1
Setting the desired water temperature
1. Repeatedly press the Up button
The display shows the desired water temperature in °C.
14
The heat pump does not work when the set desired water temperature is below the
currently measured water temperature.

Showing or setting parameters

The heat pump has 9 parameters that can be shown or set via the display
Showing parameters
1. Press and hold the SET button
The display shows "A".
14
2. Repeatedly press the Up button
The display shows the desired parameter (see "Parameters").
14
3. Press the SET button
The value of the selected parameter blinks on the display
Setting parameters
1. Repeatedly press the Up button
38
button.
.
15
or the Down button
16
for 5 seconds while the heat pump is in operating mode.
18
or the Down button
16
to select the desired parameter.
18
or the Down button
16
shows the current water temperature in °C.
14
.
17
(see "Parameters").
D
.
17
.
14
.
17