Deinstallation; Disconnecting The Supply Lines; Cleaning; Cleaning The Heat Pump - Steinbach MINI Bedienungsanleitung

Deinstallation

CAUTION!
Risk of injury when moving heavy equipment!
The device is heavy! Incorrect lifting or uncontrolled tipping of the device can
result in injuries or damage to the device.
- Only lift, carry or tip the device with two people, never alone.
- Pay attention to maintaining proper posture (straight back, secure footing,
etc.).
- Use transport aids (e.g. pallet truck, or creeper dolly).
- Wear protective equipment such as safety footwear or gloves.

Disconnecting the supply lines

Disconnecting the electrical
1. Put the heat pump into the Standby mode (see the chapter on "Display").
2. Press the RESET button 12.
3. Disconnect the RCD adapter
The heat pump is now disconnected from the electrical supply.
Disconnecting the water lines
1. Switch off the water treatment pump.
2. Loosen the hose clamps
3. Pull the end of the hose off the adapter
When removing the end of the water hose, hold it with the opening facing upwards to prevent
uncontrolled spilling of the remaining water present in the hose.
4. Unscrew the end of the hose from the adapter
When removing the end of the water hose, hold it with the opening facing upwards to prevent
uncontrolled spilling of the remaining water present in the hose.
The water lines have been disconnected.

Cleaning

NOTE!
Risk of damage due to improper cleaning!
Improper cleaning can result in damage to the device.
- Clean the surface of the device with clear water after every use.
- Do not use any aggressive cleaning agents.
- Do not use any sharp or metallic objects such as knives, hard putty knives
or the like.
- Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.

Cleaning the heat pump

1. Clean the housing and the grille of the fan
C from the electrical supply.
3 of the adapters
2 on the inlet water connection
9
2 .
2 on the inlet water connection
with a slightly damp cloth.
7 .
6 .
41