Trouble Shooting - T+A TCI 1 RE Montagehinweise

Trouble shooting

Many problems have a simple cause
which is simple to put right. In this section
we list a number of possible problems
together with the method of eliminating
them. If you meet a problem which cannot
be sorted out using these notes, then
please contact an authorised  service
workshop without delay.
Problem: 'Flat' sound image, in-
adequate bass response.
Cause: The speaker leads are not
connected 'in phase'.
Remedy: Check
between the speaker leads,
the
amplifier speaker terminals,
referring
diagram, and correct where
necessary.
Problem: Bass too powerful.
Cause: The speaker is located too
close to the wall or in a
room corner.
Remedy:
Keep the speakers at least
50 cm away from the side
walls, or alter the setting of
the 'Bass' switch on the
rear of the speaker (TAL
series).
the connections
speakers and
to the wiring
Problem:
Cause 1:
Remedy:
Cause 2:
the
Remedy:
55
No output signal at the
loudspeakers.
The amplifier's Protection
circuit has tripped due to
overheating or overloading.
Reduce volume;
amplifier does not switch
itself on again after about
20 seconds, then it has
become too hot. Leave it
switched off for a few
minutes to cool down.
Short-circuit in the speaker
leads; e. g. by stray cable
'whiskers' at the terminal
clamps, or
mechanical damage to the
cable.
Check the speaker leads
and terminal clamps. Twist
wire ends together tightly,
or fit cable end sleeves.
Replace defective cables.
if the
due to