Cross Over Units - T+A TCI 1 RE Montagehinweise

Cross-over units

All loudspeakers
outstanding features, including exceptional
peak power handling, extreme linearity of
the frequency and phase response. These
qualities are due primarily to the FSR
(Fast Signal Response) cross-over units
developed by .
The top surface of the circuit boards used
for these cross-over units features a solid
layer of copper whose sole purpose is to
act as ground conductor.
The copper tracks on the under-side
connect the electronic components. This
method of construction ensures that the
sensitive ground potential is not affected
by large signal cur-rents.
This circuit design minimises unwanted
signal influences such as intermodulation
effects and interference between the
individual transfer paths.
share certain
40
Since there are no narrow conductor
tracks to cause voltage drops, the circuits
can carry much higher cur-rents.
The cross-over unit components are of
extremely low-resistance
losses in the circuit are virtually zero.
Where large capacitance values are
required, several smaller capacitors are
connected together in parallel in order to
reduce series inductivity and rise times.
All internal wiring inside our speaker
cabinets consists of high-quality cable of
large cross-sectional area.
design, and