Bartscher C4431D Original-Gebrauchsanleitung Seite 67

Disturbance
Cooking / baking
result uneven
Upon activation of
the steaming water
is not delivered
from the hoses
Water escapes
from the seal when
the convection
oven door is
closed
The fan stops
during operation
If you cannot remove the malfunctions:
do not open the housing,
-
notify the customer service point or contact the sales agent,
-
while providing the following information:
type of malfunction;
article and serial number (rating plate at the rear of the device).
Cause
• The fan does not perform
reversing the direction of
rotation
• The fan stands still
• One of the resistors is
defective
• The water supply is closed
• The connection to the
water network is not carried
out correctly
• Water inlet filter is clogged
by dirt
• Dirty seal
• Seal damaged
• There exists a problem
when closing the oven door
hot air
• Safety thermostat of the
engine has been triggered
• Fan motor is damaged
Remedying
• Contact the customer
service
• Contact the customer
service
• Contact the customer
service
• Open the water supply
• Check the connection to
the water network
• Clean the water inlet filter
• Clean the seal with a moist
cloth
• Contact the customer
service
• Contact the customer
service
• Switch the oven door hot
air off and wait that the
overheating protection of
the engine will automati-
cally start up again.
In case the problem is
repeated, contact the
customer service
• Contact the customer
service
- 63 -