Bartscher C4431D Original-Gebrauchsanleitung Seite 61

TEMPERATURE SCALE CELSIUS / FAHRENHEIT
The temperature scale ° C (degrees Celsius) is set a t the factory. To change this,
proceed as follows:
Simultaneously press and hold the INCREASING and DECREASING keys for
4 seconds. Then press the INCREASING key until USER is shown in the display.
Press the STEAMING key to enter the menu. Press the INCREASING or
DECREASING keys in order to select the option of ° C (Celsius degree) or ° F
(Fahrenheit degree). Then confirm the selection by pressing the START / STOP key.
Press the ON / OFF key to exit the menu,
On the control panel of the convection oven it lights, depending on the selected
temperature scale, the LED CELSIUS or FAHRENHEIT.
OPENING THE DOOR OF THE CONVECTION OVEN
In the course of opening of the convection oven the micro-switches intervenes
which moves the convection oven to the pause state. It appears the light signal:
LED OPENED DOOR lights red.
If the convection oven door is closed again, the LED OPENED DOOR lights green
and the device continues the cooking cycle there, where it has been interrupted.
MISSING VOLTAGE
When it comes to power failure while performance of a cooking cycle, the convection
oven goes to OFF when there is voltage again.
MESSAGES AND ALARMS
The following alarm signs appear on the display, while all the rest will remain switched
off and it sounds an audible signal to indicate the error.
The acoustic signal can be switched off by pressing the START / STOP key.
ER1 Alarm of the sensor in the space.
This occurs when a defect of the sensor in the cooking space. All functions,
except the lighting are deactivated and the current cycle is interrupted.
ER2 Alarm at the safety thermostat of the convection oven
This occurs when a disturbance arises during the heating of the convection
oven. All functions are disabled, the current cycle is interrupted.
- 57 -